Tip: Normally, the visibility and printability should be enabled or disabled together. Remember, a visible layer cannot be printed or exported if printability is disabled, and a non-visible layer can be printed and exported if printability is enabled. A layer that is visible but non-printable can be used to keep notes with the file. I use such a layer to keep the print details and other job information, so that I can refer to them at any time.


Here is my problem. i have a series of 3 digit numbers that need to be cinverted to a series of 4 digit numbers using this following 722 needs to read as 5622 and in the next collum SV-7822 in the collum's to the right. what type of formula is this and how can i do it? The above is an example, i have a whole range of 3 digit numbers that need the exact. rules applied to all numbers. which is why i need a formula to do it. Help someone please!!!! I'm not completely clear on what your looking for but if 722 was in A1 in B1: = A1 + 4900 in B2: = ="SV-" & A1 + 7100...
Is there a way to have page numbering span multiple worksheets in a file? I would like to be able to print all the worksheets in a file and have the page numbers in the second worksheet pick up where the page numbers in the first worksheet ended without having to manually adjust the start point in worksheet 2. Please response back to the group. Thanks. JWeinberg I assume the page numbers are set up in your header/footer. If this is correct then all you need to do is select all the sheets you want to print by clicking on each sheet tab while holding down the control key. This will the...
I have been generating 150-400 page reports with multiple lists in tables. Word's auto numbering would only go so far in applying sequential numbering but then it just stops and I could not use it any more. I had to manually type in the numbered list which was quite annoying and very time consuming. Then I came across your Word Tip. Awesome! It worked. Thanks so very much.
However, what I want it to do now, instead of just putting the number into the attribute value, I want the number to be a suffix to the existing default tag value of the tag named "ID" which is "ADDRESS:" for some blocks and "ELEVATION:" for other blocks but the tag name that the routine always has to filter for is "ID". That way the user can pick anywhere on the block - not being forced to pick the tag we want to add numbers to. document numbering
×